Filter
Top Products
mfyou purchase the optional chest puJse sensor (see page 19), follow the steps below to install the receiver
included with the chest pulse sensor.
1, Remove the key from the console and unplug
the power cord.
Remove the 3/4" Screw (23) and the Access Door
(100) from the back of the ConsoUe Base (98),
2, Connect the wire on the receiver (A) to the indi-
cated wire extending from the Console Base (98),
HoJd the receiver so the small cylinder is ori-
ented as shown and is facing the ConsoJe
Base. Attach the receiver to the pUastb posts on
the Access Door (100) with the two included
small screws,
3, Make sure that no wires are pinched. Reattach
the Access Door (100) with the 3/4" Screw (23),
Discard the other wires included with the re-
ceiver,
I /
11