Filter
Top Products
With the heUpof a second person, carefully raise the
Uprights (70, 76) as shown, Carefully pivot the Hood
(28) off,
Locate the Reed Switch (39) and the Magnet (6) on
the bft side of the Pulley (7), Turn the Pulley until the
Magnet is aligned with the Reed Switch, Make sure
that the gap between the Magnet and the Reed
Switch is about 1/8", if necessary, bosen the Screw
(11), move the Reed Switch slightly, and then
retighten the Screw, Reattach the Hood, and run the
treadmHUfor a few minutes to check for a correct
speed reading,
1/8"-
11/
[
Top
View
7
PROBLEM: The walking belt slows when walked on
SOLUTION: a, Use only a singleooutlet surge suppressor that meets all the specifications described on page 12,
b,
if the walking belt is overtightened, treadmill perforo
mance may decrease and the walking belt may beo
come damaged, Remove the key and UNPLUG THE
POWER CORD, Using the hex key, turn both rear
roller bolts counterclockwise, 1/4 of a turn, When the
walking belt is properly tightened, you should be able
to lift each edge of the walking belt 2 to 3 inches
above the walking platform, Be careful to keep the
walking belt centered, Then, plug in the power cord,
insert the key, and run the treadmill for a few minutes,
Repeat until the walking belt is properly tightened,
Rear Roller Bolts
c, if the walking belt still slows when walked on, please see the front cover of this manual,
PROBLEM: The waJking belt is off-center or slips when walked on
SOLUTION: a,
If the waJking beJt is off-center, first remove the key
and UNPLUG THE POWER CORD, If the walking
belt has shifted to the Jeft, use the hex key to turn
the left rear roller bolt clockwise 1/2 of a turn; if the
walking belt has shifted to the right, turn the left
bolt counterclockwise 1/2 of a turn, Be careful not to
overtighten the walking belt, Then, plug in the power
cord, insert the key, and run the treadmill for a few
minutes, Repeat until the walking belt is centered,
b,
If the walking belt slips when walked on, first re-
move the key and UNPLUG THE POWER CORD,
Using the hex key, turn both rear roller bolts clock°
wise, 1/4 of a turn, When the walking belt is correctly
tightened, you should be able to lift each edge of the
walking belt 2 to 3 inches above the walking platform,
Be careful to keep the walking belt centered, Then,
plug in the power cord, insert the key, and carefully
walk on the treadmill for a few minutes, Repeat until
the walking belt is properly tightened,
23