Filter
Top Products
10
15. Lubricate an M10 x 70mm Bolt (55) with grease.
Attach the Leg Lever (18) to the Front Leg (12)
with the Bolt and an M10 Nylon Locknut (58). Do
not overtighten the Locknut; the Leg Lever
must be able to pivot easily.
16. Press two 19mm Round Inner Caps (25) into the
ends of a Pad Tube (24). Slide a Pad Tube
through a hole in the Front Leg (12). Slide two
Foam Pads (23) onto the Pad Tube.
Repeat this step with other Pad Tubes (24)
and the Leg Lever (18).
15
16
55
58
12
18
Lubricate
23
25
24
24
24
23
25
12
18
13. Press two 25mm Round Inner Caps (70) into two
Weight Rests (39). Insert the Weight Rests into
the Right Upright (4) and engage the locking bars
around the Upright.
Repeat this step with the other Weight Rests
(39) and the Left Upright (not shown).
13
70
Locking
Bars
Locking
Bars
70
39
4
39
14
14. Press three 45mm Square Inner Caps (34) into
the Leg Lever (18). Press a 25mm Round Inner
Cap (70) into the Weight Tube (19).
Attach the Weight Tube (19) to the Leg Lever (18)
with an M8 x 57mm Bolt (68), two M8 Washers
(63), a 12mm x 10mm Spacer (61), and an M8
Nylon Locknut (64). Press the 25mm Round
Outer Cap (62) onto the end of the Weight Tube.
18
63
64
34
19
70
34
63
68
62
61
34