Filter
Top Products
Step 9:
Cap Pec Dec Top Pulley Block (23)
with 2" End Plugs (54). Cap Pec Dec
Support (24) with 2" End Plugs (54).
Insert four 3/4" Bushings (70) into the
sleeves on the Pec Dec Support (24).
Attach Pec Dec Top Pulley Block (23)
and Pec Dec Support (24) to the Pec
Dec Upright (6) using two 1/2" x 3-1/8"
Hex Head Bolts (76), four 1/2" x 1-
1/16" Washers (89) and two 1/2" Nylon
Nuts (94).
Cap Right Pec Dec Arm (15) with two
2" Sq End Plugs (54). Slide 3/4" x 1-
1/2" Washer (87) and Pec Dec Adj Cam
(25) onto the Right Pec Dec Arm (15).
NOTE: The ringlet on the Pec Dec Adj
Cam (25) MUST face outside.
Lock the Pec Dec Adj Cam (25) with
Pop Pin (67). Slide the Right Pec Dec
Arm (15) onto the Pec Dec Support
(24) and secure with 1/2" x 1-1/4"
Washer (95) and 1/2" Nylon Nut (94).
Cap 1/2" Nylon Nut (94) with Cap for
Nut (56). Slide the 4" Pec Dec Foam
Pad (42) onto the Right Pec Dec
Arm (15).
Repeat the same procedure for the
Left Pec Dec Arm (16), Pec Dec Adj
Cam (25) and Pec Dec Sopport (24).
ASSEMBLY
assembly instructions
-16-