Filter
Top Products
assembly instructions
-15-
Step 8:
Cap Rear Upright (8) with 2" x 3"
Rect End Plug (55). Insert Guide
Rod (9) into the sleeve on Rear
Upright (8) by placing Rear
Upright (8) top-down. Attach Rear
Upright (8) to Triangular Link
Plates (27) using two 1/2" x 4-
1/4" Hex Head Bolts (73), four
1/2" x 1-1/16" Washers (89) and
two 1/2" Nylon Nuts (94).
Attach each Rear Upright (8) to
Rack (5) and Top Connect Beam
(4) using 1/2" x 4" Hex Head Bolt
(74), two 1/2" x 1-1/16" Washers
(89) and 1/2" Nylon Nut (94).
Attach 1" "C" Pin (93) to Weight
Holder (33). Insert Weight
Holders (33) into the holes in Rear
Upright (8).
NOTE: The threaded end of
Weight Holder (33) MUST face
inner side.
Then tighten with 3/8" x 1-1/4"
Washer (88) and 3/8" x 3/4" Hex
Head Bolt (82).
Slide 3" Rubber Doughnut (61)
and Short Olympic Sleeve (35)
onto Weight Holder (33) and
secure with 5/16" x 1/2" Set Screw
(86). Secure Guide Rods (9) with
5/16" x 3/8" Set Screws (85).
ASSEMBLY