Filter
Top Products
Maintenance
32
460 SeriesfOwner’s Manual
C
AUTION – FOR SAFE OPERATION
Always inspect hardware prior to any exercise session. Look for loose hardware, loose
pedals, loose cranks and frayed wires. Repair or replace any damaged or worn parts,
tighten all loose hardware.
As part of Diamondback Fitness’ normal installation and set-up process, all pedal cranks
must be tightened after 8 to 10 hours of initial riding to ensure parts are properly seat-
ed to axle. This is standard initial “break-in” service which must be performed after the
first 8 to 10 hours of use. Untightened pedal cranks may become loose, causing dam-
age which may void the warranty.
After training, always wipe down your 460 model unit. Perspiration that continuously
settles on frame, pads or casing may eventually cause rust to the unit. Damage result-
ing from lack of proper maintenance will not be covered under warranty. To clean
pads, use a mild soap and warm water. Dry with a clean towel.
If noises develop or malfunctions occur, contact your authorized Diamondback Fitness
dealer.