ENG-23ENG-22
ENG
F-01 F-02 F-03 F-14
• Trip distance
• Elapsed time
• Various average values (average speed, and average cadence)
• Various maximum values (maximum speed, and maximum cadence)
• Date and time of file creation (date/time when the measurement started)
• Number of laps used
• Time distribution to the target zone (time in the zone, time above the zone, and
time below the zone) and the percentage (%)
• Lap data (average lap speed, average lap cadence, maximum lap speed, maxi-
mum lap cadence, lap time, split time, trip lap distance)
*1: One lap per file is used even in the case there is no lap data. Therefore, when the total
number of laps reaches 99 points, no more files can be saved.
Viewing the measurement data in a file
View the measurement data in a file saved in the computer.
1. Press the MENU button in the measurement screen to
switch to the menu top screen.
Press the SSE button on the FILE VIEW screen.
Menu top:
MENU
Confirm:
SSE
File view
The lap and measurement data are saved into a file automatically each time a ride is reset
(Resetting Operation page 16)
With the file view, you can review the past rides or delete data recorded.
Measurement data to be recorded in a file
The computer can record up to 14 files
*1
.
When 14 files (rides) are saved, the oldest one is deleted automatically. The latest file
is always F-01.
The measurement data to be saved in a file are as follows.
Date of creation:
Old
Total number of laps
Total number of files
(Back)
New
M2/-
Changing the computer configuration
Pressing the MENU button in the measurement screen switches to the menu screen.
In the menu screen, you can view and delete the files saved, and view and change various
configurations.
*Use the M1/+ and M2/- to change menu items.
* After changes are made, be sure to review the setting(s) and confirm by pressing the MENU button.
*Leaving the menu screen without any operation for 2 minutes returns to the measurement screen,
and changes are not saved.
Menu top screen
Measurement
screen
M1/+
MENU
(Back)
Setting the measure-
ment unit
Changing the measure-
ment unit
MENU
(Back)
SSE
(page 30)
File view
Viewing and deleting
files
SSE
(page 23)
Setting the clock/
date
Changing the clock/date
SSE
(page 27)
Wheel selection and
tire circumference
Selecting wheel and
changing the tire cir-
cumference
SSE
(page 28)
Searching the sen-
sor ID
Synchronizing the speed
sensor ID
SSE
(page 28)
Total distance
manual entry
Total distance input
SSE
(page 30)
Setting the auto-
mode
On/off of the auto-mode
SSE
(page 31)
Setting the count-
down distance
Countdown distance in-
put
SSE
(page 31)
Setting sound
On/off of the CDC alarm,
and button operation
sound
SSE
(page 32)
Setting the target
cadence zone
Changing the upper/
lower zone limit
SSE
(page 33)
Continue