Filter
Top Products
19
Figure 26 - Squat Cables
Snap
Hook
Squat Bar
Snap
Hook
Step 24 - Route the Lat Cables
Locate the following items:
• Item #S - (2) Hand Grips
• Item #R - (1) Bent Lat Bar (optional)
• Item #Z - (2) Lat Cables with (2) Snap Hooks (attached)
Unwrap the Lat Cables with Snap Hooks from both Pulleys on
the Lat Cross Bar. Pull one end of the Cables down from the Lat
Cross Bar, and fasten to the Chest Cable Snap Hook.
Fasten the attached Snap Hook from the Lat Cable to a Hand
Grip or the Bent Lat Bar. Repeat for remaining Lat Cable.
Step 25 - Route the Leg Cables
Locate the following items:
• Item #AA - Leg Cable
• From Step 14 - Leg Extension Seat Assembly
Unwrap the Cables from the Rear Leg Pulley.
Pull one end of the “Y” Cable away from the Rear Leg to fasten to
a Snap Hook on the Rod Cable.
Note: For this step, make sure your Leg Extension Seat is installed.
Step 26 - Route the Squat Cables
Locate the following items:
• Item #R - Squat Bar
Unwrap the Cables on each Base Leg Pulley. Pull one end of the
Cable up from the Leg Pulley, and fasten the Cable to a Snap
Hook on the Chest Bar.
Fasten the Snap Hook attached to the Squat Cables to the
corresponding Squat Bar “D” Ring.
Repeat for remaining Squat Cable.
CONGRATULATIONS! You have successfully completed assembly
of your Bowflex
Sport® Home Gym! Please inspect your machine
to ensure that all fasteners are tight and everything is properly
assembled. Review all warnings that are affixed to the machine.
Figure 25 - Leg Cables
Snap
Hook
Leg
Extension
Seat
Figure 24 - Lat Cables
Hand Grips
or Bent
Lat Bar
Snap
Hook
Snap
Hook
Assembly Guide