Filter
Top Products
52-53
52 53
both the speed and elapsed time can be retrieved.
Lap Time & Speed Recall
Similar to the Chrono Recall mode, during speed
measurement or Stop state, you can press
[RECALL] to recall the speed/lap memories.
The Mode message will be shown for one to
two seconds as the Mode message display is
displayed.
The Speed and Lap time will be displayed on the
upper and the middle lines. The lower line shows
the current time counting. During Data recall, the
fastest speed will be reviewed fi rst, then the slow-
est speed and average speed.
Before starting again, you can reset the timer by
pressing [STOP • RESET].
Note: When you reset the Speed timer, the speed
measurement starts again from a reset state, and
all speed records in memory will be cleared (pro-
vided that the storage is not under segmented run
memory mode).
The Recall function is similar to chronograph
recall. If segmented run memory is selected, the
DATA mode can be accessed and records storing
RECALL
Speed Mode
after reset.
54-55
54 55
Further presses of [RECALL] will retrieve the
memories in ascending order or reverse order
depending on whether the speed measurement is
stopped or under operation respectively. During
Recall, the “Recall” indicator is ON.
(Note: Speed mode and Chrono mode will
not run simultaneously. When Chrono mode
is active, Speed mode should be in reset
state and vice versa.)
Please register your new stopwatch at www.ACCUSPLIT.com/support or
send this form to address on the back cover of this instruction booklet
Email (preferred)
User
NO-PROOF-OF-PURCHASE LIMITED WARRANTY
See label on back of unit for details, or check
http://support.ACCUSPLIT.com