Filter
Top Products
40-41
40 41
How to set the timer
Press and hold [RECALL] (S1) for 2 seconds to
activate timer setting. Timer setting starts with
second digits, which are shown blinking. You can
press [START • SPLIT] (S3) to advance the fl ashing
digits. Or you can press [STOP • RESET] (S2) to
select other digits. The setting follows the
sequence: second, minute, hour and timer
operating mode (CR, CS and CU).
NOTE: You can only set Hour, Minute and Seconds.
The 1/10 second cannot be set.
Press and hold [RECALL]
for 2 seconds. Timer
setting starts with
second digits.
Press [STOP • RESET] (S2)
to move to minute digits.
Press [STOP • RESET] (S2)
further to go to hour digits.
Hour digits can be adjusted
from 0 to 19.
Press [STOP • RESET] (S2)
again to adjust the operating
mode. Press [START] to switch
the operating modes among
CR, CS and CU.
At the end of setting, press
[RECALL] (S4) or [MODE] to
leave setting mode.
42-43
42 43
Pacer Mode
Press [MODE] until you enter the Pacer mode.
In the Pacer mode, you can set the standard
pacer speed from 5 to 240 beats per minute in
the following values:
5, 10, 20, 30, 40, 50, 60, 80, 100, 120, 150, 180,
200, 240
In Pacer mode, the display will be:
° 5 beats per minute
The digits are fl ashing to indicate that the pace
count is ready for setting. Press [STOP • RESET] to
select the pace count. Once the desired pace count
is selected, press [START • SPLIT] to confi rm the
PACER
P - 5
setting and start the pace count. The display will
show the elapsed time on the upper line, the pace
count number on the middle and the pace count
value on the lower display.
° Elapsed time
° Pace count number
° PACE count
Press [STOP • RESET] to stop the pace count; the
display will freeze. To restart the
pace count, press [START • SPLIT]
again. Or press [STOP • RESET]
to reset the time elapsed and the
pace count number .