Filter
Top Products
44-45
44 45
Stroke/Stride Measurement
Press [MODE] until you enter the Stroke Measure-
ment mode. The display will be as follows.
In the Stroke or Strides Measurement mode,
the duration of 3 strokes is taken and the stroke
frequency (counts per minute) is calculated. If the
stroke frequency falls out of the range of 10 - 180,
“Err” will appear to show the error condition.
Press [START • SPLIT] to start the measurement.
During the 1st second, 180.0 will be shown and
fl ashing as below.
STROkE
0.0
At the end of the fi rst second, the display will
become steady.
If measurement is stopped in the fi rst second
(stroke frequency > 180), error signal “ Err “ will
be shown. After the fi rst second has elapsed,
the instantaneous measurement reading will
be shown. When you press [STOP • RESET], the
display will show the steady stroke measurement
reading. If the measurement lasts for more than
18 seconds (stroke frequency < 10), an error signal
“Err” will be displayed. When the measurement
is stopped, press [STOP • RESET] to reset the
displayed reading to “0.0”.
STROkE
180.0
46-47
46 47
Speed Mode (AX602M500 Model only)
Press [MODE] until you enter the Speed mode.
The display will be as follows.
° Distance
° Lap time
° Total time
(Note that the default setting is KM. Hence “KM”
icon will be ON.)
The upper line shows the distance or speed. The
lap time is in the middle line, while the total time
is displayed on the lower line.
In Speed mode, you can record a number of lap
times and speeds for covering the distance you
program into the chronograph. Before starting to
use the Speed mode, you need to enter the dis-
tance as explained below. Otherwise, the speed
measurement won’t work. Nothing will happen
when you press [START • SPLIT].
Distance Setting
Press [RECALL] (S1) for 2 seconds to enter setting
mode. The unit icon fl ashes.
Distance units
Distance indicator (only
used in speed mode