Filter
Top Products
11
2.3.2 AC Adapter Connection
This 3M
™
Shoes and Wrist Strap Tester 747 can be operated from six “AA”
alkaline batteries or the supplied AC adapter. The AC adapter has priority, so
when the batteries are installed and the adapted is connected, battery power is
not drained.
1. Confirm that the power switch is turned off.
2. Connect the output plug from the AC Adapter to the
mating jack on the side panel.
3. Check to ensure that your AC mains voltage matches the
voltage rating of the AC Adapter, and then plug it in.
2.4 Turning Power On and Off
Turning Power On
1. Set the power switch on the side panel of the
3M
™
Shoes and Wrist Strap Tester 747 to the on
position (|).
2. Press a finger on the touch panel on the front of
the Shoes and Wrist Strap Tester 747 to switch it
on and begin a test.
Turning Power Off
Set the power switch on the side panel to the off position (O).
Power Saver Function
The power saver function conserves power by automatically turning the Shoes
and Wrist Strap Tester 747 off (or entering stand-by state during AC operation)
ten seconds after completing a test. This function is disabled when using RS-
232C communications.
To reduce the risks associated with hazardous voltage, which, if not avoided, may result in minor or
moderate injury and/or property damage:
• AC adapter must have all local required regulatory certifications.
• Do not use AC adapter and/or power cord if damaged.
CAUTION