166 G7 ASD Operation Manual
Torque Limit Group
No path available (Direct Access Only)
While operating using the LED Keypad Option this parameter is used to select
1 of 4 preset positive torque limits to apply to the active motor. The settings of
profiles 1 – 4 may be setup at
F441, F444, F446, and F448, respectively.
Settings:
1
2
3
4
Note: If using the LCD EOI, press ESC from the Frequency
Command screen to access this parameter.
Direct Access Number — F723
Parameter Type — Selection List
Factory Default — 1
Changeable During Run — Ye s
Feedback in Panel Mode
No path available (Direct Access Only)
While operating using the LED Keypad Option this parameter Enables/
Disables PID feedback control.
Settings:
Enabled
Disabled
Note: If using the LCD EOI, press ESC from the Frequency
Command screen to access this parameter.
Direct Access Number — F724
Parameter Type — Selection List
Factory Default — Enabled
Changeable During Run — Ye s
LED Option Override Multiplication Gain
Program ⇒ Feedback Parameters ⇒ Override Control
If operating using the LED Keypad Option this parameter provides a value to
be used in the event that Setting is selected for the Frequency Override
Multiplying Input (
F661).
Direct Access Number — F729
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye s
Minimum — -100.00
Maximum — 100.00
LOD Control and Stopping Method
Program ⇒ Special Control Parameters ⇒ Low Output Disable Function
⇒ LOD
Enables/Disables the Low Output Disable function and, if enabled, selects a
stopping method.
Settings:
Disabled
Enabled — Decel Stop
Enabled — Coast Stop
Direct Access Number — F731
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — Ye s
LOD Start Level (Hz)
Program ⇒ Special Control Parameters ⇒ Low Output Disable Function
⇒ LOD Start Level (Hz)
The Low Output Disable Start Level sets the output frequency threshold that,
if exceeded, will initiate the LOD function if properly configured.
Direct Access Number — F732
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Ye s
Minimum — 0.0
Maximum — Max. Freq.
Units — Hz
F723 F732
