A SERVICE OF

logo

Installing the speakers
Your interactive flat panel comes with two 15 W speakers.
g To install the speakers
1. Attach the speakers to the speaker mounting holes on the side of the interactive flat panel with
the included screws.
2. Connect the speaker wires to the speaker wire connections.
I MP OR TA N T
Do not connect the speakers to the wired remote control 3.5 mm jacks. These are not audio
connections. The remote control is disabled while anything is inserted into these jacks.
3. Run the speaker wire for the left speaker (when viewed from the back of the interactive flat
panel) below the bottom terminal panel and secure it with the included small clamps.
C HA PT ER 3
Connectingcomputersandperipheraldevices
16