Important mounting considerations for trained installers
Consider the following when mounting the interactive flat panel on a wall:
l Attach the included M12 eyebolts and washers to assist in mounting, and remove them after
you wall-mount the interactive flat panel.
W AR NI NG
Do not attempt to mount orcarry the interactive flat
panel using your own strength because it could fall and
cause personal injury. Attach a lifting device to the
included M12 eyebolts to lift and carry the interactive
flat panel.
C AU TION
Hand-tighten the M12 eyebolts. If you over-tighten the eyebolts and damage the threads, you
will be unable to remove the eyebolts.
ll Plan your workflow to include cabling because some cable connection points might not be
accessible after installation.
I MP OR TA N T
Attach the speakers and connect the speaker wires to the interactive flat panel before you
wall-mount it. For more information, see Installing the speakers on page 16.
l To mount the interactive flat panel on awall, you require a standard VESA 400 mm × 400 mm
mounting plate (not included).
l Use M8 screws to fasten the wall bracket. The screws must be 14–15 mm long plus the
thickness of the bracket and the washer.
l The recommended fasten force is 99.57–121.70 in-lb. (11.25–13.75 N·m).
l Refer to the instructions included with the mounting equipment for more detailed information.
Choosing a mounting location
Consider the following when you select a location for the interactive flat panel:
l The wall must be strong enough to support the interactive flat panel and the mounting
equipment. The interactive flat panel weighs 262 lb. (119 kg).
l Do not install the interactive flat panel in a location where a door or gate could hit it.
l Do not install the interactive flat panel in an area where it will be subjected to strong vibrations
or dust.
C HA PT ER 2
Installingyour interactiveflatpanel
13
