3 - 14
43 start character match for Code 93, 43h = “C”
FF termination string for third code
Output Sequence Editor
Require Output Sequence
When an output sequence is Required, all output data must conform to an edited sequence or the doc-
ument reader will not transmit the output data to the host device. When it’s On/Not Required, the docu-
ment reader will attempt to get the output data to conform to an edited sequence, but if it cannot, the
document reader transmits all output data to the host device as is.
When the output sequence is Off, the barcode data is output to the host as the document reader
decodes it.
Default = Off.
Note: This selection is unavailable when the Multiple Symbols Selection is turned on.
Multiple Symbols
When this programming selection is turned On, it allows you to read multiple symbols with a single pull
of the Document Reader’s trigger. If you press and hold the trigger, aiming the Document Reader at a
series of symbols, it reads unique symbols once, beeping (if turned on) for each read. The document
reader attempts to find and decode new symbols as long as the trigger is pulled. When this program-
ming selection is turned Off, the Document Reader will only read the symbol closest to the aiming beam.
Default = Off.
Enter Sequence
Default Sequence
Required
On/Not Required
*Off
