12 - 1
12
Maintenance
Repairs
Repairs and/or upgrades are not to be performed on this product. These services are to be performed
only by an authorized service center. See "Customer Support" on page 13-1 for further information.
Maintenance
Your document reader provides reliable and efficient operation with a minimum of care. Although spe-
cific maintenance is not required, the following periodic checks ensure dependable document reader
operation:
Cleaning the Document Reader
Reading performance may degrade if the document reader’s window is not clean. If the window is visibly
dirty, or if the document reader isn’t operating well, clean the window with a soft cloth or lens tissue
dampened with water (or a mild detergent- water solution). If a detergent solution is used, rinse with a
clean lens tissue dampened with water only.
The document reader’s housing, the stand, and the tray should also be cleaned the same way.
Inspecting Cords and Connectors
Inspect the document reader’s interface cable and connector for wear or other signs of damage. A badly
worn cable or damaged connector may interfere with document reader operation. Contact your distribu-
tor for information about cable replacement. Cable replacement instructions are on page 12-1.
Replacing the Interface Cable
The standard interface cable is attached to the document reader with an 10-pin modular connector.
When properly seated, the connector is held in the document reader’s imager by a flexible retention tab.
The interface cable is designed to be field replaceable.
• Order replacement cables from Honeywell or from an authorized distributor.
• When ordering a replacement cable, specify the cable part number of the original interface cable.
!
Caution:
Do not submerge the document reader in water.
Do not use abrasive wipes or tissues on the document reader’s
window or casing.
Never use solvents (e.g., acetone, benzene, ether, or phenol-
based agents) on the stand, housing, or window. Solvents may
damage the stand, housing, or window.
