Eiki International LC-XG210 Manual

A SERVICE OF

next previous

Note:

Do not replace the LCD panel

separately otherwise it can

not obtain proper picture.

-14-

1 Remove 4 hex screws A and take the LCD/Prism ass’y off upward.

2 Remove each 1 screw B and take the Glass Holder, and then pull the

Optical filter, Polarized Glass-Out upwards off. These glasses are mounted

for R, G and B LCD panels respectively.

Note:

To avoid the CG and focus alignments slipping off, please be careful to han-

dle the LCD/Prism ass'y.

* Glasses should be placed as the

sheet attached side comes to the

LCD panel side.

Prism ass’y removal and disassembly

3-

1

A

A

A

Optical Pats Disassemblies

B

Polarized Glass-

Out

A

Fig.3-2

Fig.3-

1

Optical Filter

Optical Filter(WV)

Optical Filter(WV)

Optical Filter(WV)

Optical Filter(WV)

Polarized Glass

Polarized Glass

Polarized Glass

Polarized Glass

1AV4Z15B180

Film

R-PANEL

B-PANEL

G-PANEL

PRISM

PRISM

PRISM

The polarized glasses and optical filters in the prism assembly are installed

as figure below. Please be careful for the mounting.

The polarized glasses are placed as the film attached face comes outside.

The optical filters are placed as the face on which the part no. is printed

comes to the arrow direction as shown in the figure. The optical filters for B

and G panel have films on the both of the faces.

Polarized glass and optical filter mounting direction

3-

2

Fig.3-3Fig.3-4