show power
CF-828
Cisco IOS Configuration Fundamentals Command Reference
July 2008
Usage Guidelines The interface-number argument designates the module and port number. Valid values for
interface-number depend on the specified interface type and the chassis and module that are used. For
example, if you specify a Gigabit Ethernet interface and have a 48-port 10/100BASE-T Ethernet module
that is installed in a 13-slot chassis, valid values for the module number are from 1 to 13 and valid values
for the port number are from 1 to 48.
Valid values for vlan-id are from 1 to 4094.
The Inline power field in the show power output displays the inline power that is consumed by the
modules. For example, this example shows that module 9 has consumed 0.300 A of inline power:
Inline power # current
module 9 0.300A
Examples This example shows how to display the available system power:
Router> show power available
system power available = 20.470A
Router>
This example shows how to display power-supply redundancy mode:
Router# show power redundancy-mode
system power redundancy mode = redundant
Router#
This command shows how to display the system-power status:
Router> show power
system power redundancy mode = combined
system power total = 3984.12 Watts (94.86 Amps @ 42V)
system power used = 1104.18 Watts (26.29 Amps @ 42V)
system power available = 2879.94 Watts (68.57 Amps @ 42V)
Power-Capacity PS-Fan Output Oper
PS Type Watts A @42V Status Status State
---- ------------------ ------- ------ ------ ------ -----
1 WS-CAC-3000W 2830.80 67.40 OK OK on
2 WS-CAC-1300W 1153.32 27.46 OK OK on
Note: PS2 capacity is limited to 2940.00 Watts (70.00 Amps @ 42V)
when PS1 is not present
Pwr-Allocated Oper
Fan Type Watts A @42V State
---- ------------------ ------- ------ -----
1 FAN-MOD-9 241.50 5.75 OK
2 241.50 5.75 failed
Pwr-Requested Pwr-Allocated Admin Oper
Slot Card-Type Watts A @42V Watts A @42V State State
---- ------------------ ------- ------ ------- ------ ----- -----
1 WS-X6K-SUP2-2GE 145.32 3.46 145.32 3.46 on on
2 - - 145.32 3.46 - -
12.2(18)SXF The output was changed to include information about the high-capacity
power supplies.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
Release Modification
