6
7
8
Print out the tie line translation and make sure that the
ports are configured as described in step 4.
> If the tie lines are translated correctly, go
on to
step 7.
> If the tie lines are not translated correctly
according to Form lb, repeat steps 4 through 6. If
the tie lines still aren’translated correctly, call the
National Service Assistance Center (NSAC)
at
l-800-628-2888 for help.
Remove the bridging clips and connect the tie line
ports to the network interface (a 66-type connecting
block).
From the 66-type block, cross-connect he line port 1 to
one of the ports you want to test (ports 2,3, or 4). See
Figure 4-3.
.
NOTE:
Test only one port at a time.
4-24 Tie Line Troubleshooting
