TYPE
CHANGING SYSTEM
6 Continue administration or leave administration mode
by sliding the T/P switch to the center position.
If you change the system type (square, pooled, or behind-
switch), you
delete all system line administration and
voice terminal programming formerly in place.
You'll
have to reassign the lines and reprogram all the voice
terminals, since this change resets them to the default
configuration. Check Form 1e, System Form-
Requirements and Options for Release 3 or the System
Configuration Form for Feature Module 2 to determine the
system type: square, behind-switch, or pooled. (The
default setting is pooled with Button Access to Line
Pools.)
If the system is to be pooled, determine the method to be
used to access line pools: Button Access, Dial Access, or
Automatic Route Selection (ARS). If you change it from
Button Access to either Dial Access or Automatic Route
Selection (ARS), the system automatically assigns a
different function to the two buttons above
Intercom-
Voice
on voice terminals. If the system is administered
for Dial Access or ARS and you change it to Button
Access, the system assigns the main pool to the two
buttons above
Intercom-Voice
on voice terminals. The
system automatically removes the main pool from any
other buttons to which it was assigned at voice terminals
throughout the system.
NOTE:
Be sure to record the
changes on the appropriate
planning forms.
With a Display Console
1 Enter administration mode by
sliding the T/P switch to
P.
2 Press
Conference
twice.
The administration menu appears.
3-66 Administering a Changed System
