Filter
Top Products
9
21
11
10
27
22
8
7
6. Hold the Handrail (27) near the Left and Right Uprights
(11, 10). Connect the Handrail Wire (21) to the Reed
Switch Wire (22). Insert the Wires down into the Left
Upright.
Attach the Handrail (27) to the Uprights (11, 10) with four
M8 x 15mm Screws (7) and four M8 Washers (8). Be
careful not to pinch the Wires (21, 22). Do not fully
tighten the Screws yet.
Place the treadmill in the storage position (see page 13).
Center the Frame (not shown) between the Uprights (11,
10).
See step 1. Tighten the four M8 Nylon Nuts (2). Then,
tighten the M8 x 15mm Screws (7). Lower the Frame
(see page 13).
8
7
6
5a
5. Align the hole on the Frame (14) with the hole in the
Right Upright (10). Insert the Pin (15) into the holes in
the Upright and the Frame. Make sure that the Pin is
fully inserted.
Look under the Frame (14) near the Left Upright (11).
See drawing 5b. Locate the Reed Switch Clip (16)
attached to the underside of the Frame. Insert the Reed
Switch (17) into the Reed Switch Clip as shown. Next,
locate the Magnet (18) on the Flywheel (19). Turn the
Flywheel until the Magnet is aligned with the Reed
Switch. Move the Reed Switch so that there is a
1/8" (3 mm) gap between the Reed Switch and the
Magnet.
18
19
16
17
1/8 in.
View from
below
5b
14
14
15
20
10
11