Filter
Top Products
7
• To watch an assembly
video, go to
http://productvideo.co/
assembly/kmart/weslo
or use your mobile
phone or smartphone to
read the QR code at the
right. A reader applica-
tion such as ShopSavvy
must be installed on your mobile phone or
smartphone.
• To hire an authorized service technician
to assemble your exercise equipment, call
1-800-445-2480.
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materialsuntilyounishallassemblysteps.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
• Left parts are marked “L” or “Left” and right parts
are marked “R” or “Right.”
• To identify small parts, see page 6.
• Assembly requires the following tools:
the included hex key
one adjustable wrench
To avoid damaging parts, do not use power tools.
ASSEMBLY
1
2
2
3
3
1
Hole
Holes
Holes
1
1. Identify the Right Upright (10), which has a single hole
in the indicated location. (Note: There is a wire inside of
the Left Upright [11].) Hold the Right Upright against the
Base (12) as shown, and orient the Right Upright so that
the two indicated holes are on the side shown.
Attach the Right Upright (10) to the Base (12) with two
M8 x 50mm Bolts (1), two M8 Curved Washers (3), and
two M8 Nylon Nuts (2) as shown. Make sure that the
curved sides of the Washers are against the Base. Do
not tighten the Nylon Nuts yet.
Attach the Left Upright (11) to the Base (12) in the
same way. Make sure that the Left Upright is oriented so
that the two indicated holes are on the side shown. Do
not tighten the Nylon Nuts yet.
10
11
12
3
2
1
2
3