Filter
Top Products
10
10. Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or car-
pet, place a mat under the treadmill.
25
9. Remove the paper backing from the Adhesive Clip (25).
Press the Adhesive Clip onto the left side of the Frame
(14) in the indicated location. Press the Hex Key (26) into
the Adhesive Clip.
Make sure that the walking belt is properly tightened (see
SYMPTOM 3 on page 14).
26
14
9
Tab
7. The Console (23) requires two “AAA” batteries. Alkaline
batteries are recommended. Do not use old and new bat-
teries together or alkaline, standard, and rechargeable
batteries together.
Press the indicated tab on the Battery Cover (24), and
remove the Battery Cover. Insert two batteries into the
two battery clips; make sure that the negative (–) ends
of the batteries are touching the springs in the bat-
tery clips.
24
23
7
8. See drawing 8a. Hold the Console (23) near the
Handrail (27). Connect the wire on the Console to the
Handrail Wire (21).
Attach the Console (23) to the Handrail (27) with two M4
x 12mm Screws (9). Do not overtighten the Screws.
Make sure that the wires are not pinched.
See drawing 8b. Press the Battery Cover (24) back onto
the Console (23).
23
9
23
24
8b
8a
27
Console
Wire
Batteries
21