Filter
Top Products
8
5. Insert the tab on one of the Handrail Brackets
(5) into the slot in the right Upright (69). Attach
t
he Handrail Bracket with a 3/4" Screw (2).
Attach the other Handrail Bracket to the left
U
pright (not shown) in the same way.
6. Set the Console (43) face-down on a soft sur-
face to avoid scratching the Console. Next, hold
a Handrail (71) near the console wire. Insert the
console wire into the hole in the side of the
Handrail. Grasp the tie and pull the console wire
out of the hole in the top. Then, attach the
ground wire to the Handrail with a Silver Ground
Screw (96).
Set the Handrail (71) on the Console (43).
Attach the Handrail with three 3/4" Screws (2).
Make sure that the console wire is not
pinched. Start all three Screws before tight-
ening any of them; do not overtighten the
Screws. Insert the excess ground wire back into
the opening in the Console.
Attach the other Handrail (not shown) to the
Console (43) as described above. Note: There
are no wires on the other side.
6
2
69
5
S
lot
5
71
Tie
96
43
Console Wire
Ground Wire
2
2
2
7. Remove the tie holding the Wire Harness (42) to
the right Upright (69). With the help of a second
person, hold the Console (43) near the right
Upright.
Remove the tie from the console wire. Connect
the Wire Harness (42) to the console wire.
See
the inset drawing. The connectors should
slide together easily and snap into place. If
the connectors do not slide together easily and
snap into
place, turn one connector and try
again.
IF THE CONNECTORS ARE NOT CON
-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON. Then, insert the connectors and
the excess wire into the right Upright (69).
69
42
43
7
42
Console
Wire
Console
Wire
Tab