Filter
Top Products
16
HOW TO USE A SPEED PROGRAM
1
. Insert the key into the console.
S
ee HOW TO TURN ON THE POWER on page
12.
2. Select one of the speed programs.
To select a speed pro-
gram, press the
Program Select button
repeatedly until “P 5” or
“P 6” appears in the
upper display. The max-
imum speed setting of the selected program will
also flash in the display for a few seconds.
3. Press the Start button or the Speed increase
button to start the program.
When you press either button, the treadmill will au-
tomatically adjust to the speed setting that is pro-
grammed for the first segment of the program. Hold
the handrails and begin walking.
Each program consists of 30 one-minute segments.
One speed setting is programmed for each seg-
ment. Note: The same speed setting may be pro-
grammed for consecutive segments. The profiles
on the console show how the speed of the walking
belt will change during the programs.
During the program, the
profile will show your
progress. The flashing
segment of the profile
represents the current
segment of the pro-
gram. The height of the
flashing segment indicates the speed setting for the
current segment. At the end of each segment, a se-
ries of tones will sound and the next segment of the
profile will begin to flash. If a different speed setting
is programmed for the next segment, the speed set-
ting will flash in the display to alert you.
The program will continue in this way until the last
s
egment of the profile flashes in the display and the
last segment ends. The walking belt will then slow
to a stop.
If the speed setting for the current segment is too
high or too low, you can manually override the set-
ting by pressing the Speed buttons.
When the cur-
rent segment of the program ends, the treadmill
will automatically adjust to the speed setting for
the next segment.
To stop the program at any time, press the Stop
button. To restart the program, press the Start but-
ton or the Speed increase button. The walking belt
will begin to move at 1 mph. When the next seg-
ment of the program begins, the treadmill will auto-
matically adjust to the speed setting for that seg-
ment.
4. Change the incline of the treadmill as desired.
See step 5 on page 12.
5. Follow your progress with the displays.
See step 6 on pages 12 and 13.
6. Measure your heart rate if desired.
See step 7 on page 13.
7. Turn on the fan if desired.
See step 8 on page 13.
8.
When you are finished exercising, remove the
key from the console.
See step 9 on page 13.
Current Segment