Weslo WATL27105.1 Treadmill User Manual


 
9
12. Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep
the included hex key in a secure place; the hex key is used to adjust the walking belt (see page 18). To pro-
tect the floor or carpet, place a mat under the treadmill.
10. Lower the Handrails (53, 59) until they are touching the
floor.
See 10a. Position the Handrails (53, 59) so the tread-
mill Frame (79) is centered between them.
Firmly tighten the four 2 1/2” Bolts (65), the two 2” Bolts
(62), and the two 4” Bolts (70). Be careful not to over-
tighten the Bolts.
53
53, 59
79
70
79
59
Top View
10
10a
65
62
65
2
48
53
Knob
Spring
Large Hole
Collar
Pin
11.Orient the Latch Housing (48) so the large hole is on the
indicated side. Attach the Latch Housing to the Left
Handrail (53) with two 3/4” Screws (2); start both Latch
Screws and then tighten them.
Remove the knob from the pin. Make sure that the collar
and the spring are on the pin. (Note: If there are two col
-
lars, place one on each side of the spring.) Next, insert
the pin into the Latch Housing (48). Then, tighten the
knob back onto the pin.
11
52
6
0
Opening
54
9. Insert the excess Wire Harness (60) into the large hole
in the side of the Right Handrail (59). Securely tighten
t
he plastic ties on the bottom of the Console Base
(52) to prevent the Wire Harness from slipping.
Then,
c
ut off the ends of the plastic ties.
Route the Wire Harness (60) through the indicated
opening in the Console Base (52). Attach the Wire Cover
(54) to the Console Base with a 1/2” Silver Screw (90).
Tighten two 3/4” Screws (2) into the Console Base (52).
Tighten the two Crossbar Screws (92).
9
59
92
90
2
Ties