Filter
Top Products
3/4Ó Screw (6)Ð16
1Ó Bolt (71)Ð2
Internal Star
Washer (72)Ð4
1 1/4Ó Bolt (104)Ð4
Wheel Bolt (107)Ð2
Wheel Nut (21)Ð2
2Ó Silver Screw (93)Ð2
1 1/4Ó Screw (92)Ð2
5/16Ó Star
Washer (127)Ð2
For help identifying the assembly hardware, refer to the drawings below. Note: The assembly hardware and other
small parts are packaged in separate part bags. Do not open the part bags until instructed to do so. (The
part bags are not labeled according to the order in which they are to be opened.) If a part is not found in
the part bags, check to see if the part has been preassembled.
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included allen wrenches and your own phillips screwdriver
wire cutters , rubber mallet , and adjustable wrench .
6
1. Open part bag B. Identify the Right Upright (82) (the
Left Upright [69] has a large round hole in the location
shown). Lay the Right Upright flat. Cut the plastic ties off
the lower end of the Right Upright. Next, feed the Wire
Harness (83) into the bottom of the Right Upright and
pull it out of the hole in the top. Note: There may be a tie
on the end of the Wire Harness to help you pull it
through the hole.
Attach the Right Upright (82) to the bracket on the right
side of the Base (109) with two 1 1/4” Bolts (104) and
two Internal Star Washers (72). (Note: It may be helpful
to use a rubber mallet to fully insert the Right Upright
into the bracket.)
Do not tighten the Bolts yet. Be
careful not to damage the Wire Harness.
Attach the Left Upright (69) to the left side of the
Base (109) in the same way. Note: There is not a wire
harness on the left side.
82
83
1
69
Hole
109
104
72
Bracket