Filter
Top Products
21
61
61. Turn the Squat Backrest (35) so that the four screw
holes are closer to the bottom of the Squat
Backrest than the top. Attach the Squat Backrest to
the Squat Bracket (37) with four 1/4” x 3/4” Screws
(114).
Turn the knob on the Adjustment Knob (115) coun-
terclockwise several times to loosen it. Next, pull
the Knob and slide the Squat Bracket (37) down
onto the Squat Slider (38). Engage the Knob into
one of the holes in the Squat Slider, and then turn
the Knob clockwise until it is tight.
62. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. See the
CABLE DIAGRAMS on page 26 and 27 of this manual for proper cable routing. If there is any slack in
the cables, you will need to remove the slack by tightening the cables. See TROUBLESHOOTING on
page 25.
35
37
38
115
114
114