Filter
Top Products
12
20. Remove the preattached 3 1/2” Pulleys (78) from
the Small Pulley Plates (31).
Wrap the Swivel High Cable (74) over a 3 1/2”
Pulley (78). Attach the Pulley and a Cable Trap (68)
to the second set of holes from the top of the Small
Pulley Plates (31) with a 3/8” x 2” Bolt (100) and a
3/8” Nylon Locknut (87). Make sure the Cable
Trap is turned to hold the Cable in the groove of
the Pulley.
21. Wrap the Swivel High Cable (74) over a 4 1/2”
Pulley (119). Attach the Pulley inside of the indicat-
ed bracket on the Top Frame (6) with 3/8” x 1 3/4”
Bolt (93) and a 3/8” Nylon Locknut (87).
22. Lift the Weight Tube (43) and the Top Weight (45)
closest to the Swivel Upright (5). Make sure that the
small pin on the Weight Tube is inside of the groove
under the Top Weight.
Insert a Weight Pin (50) into the stack of Weights
(44). Place a 1/2” Washer (1) on top of the Weight
Tube (43). Tighten a 1/2” Nut (118) halfway onto the
end of the Swivel High Cable (74). Screw the end of
the Cable two full turns into the Weight Tube. Then,
tighten the 1/2” Nut against the 1/2” Washer.
23. Locate the Swivel Cable (17), which is 115 3/8”
long and has an eyelet on each end. Attach the
Cable inside the Top Frame (6) with a 5/16” x 2 1/2”
Bolt (59), two 5/16” Washers (90), and a 5/16”
Nylon Locknut (86).
23
20
21
22
74
118
1
43
44
45
50
5
6
74
74
87
87
93
31
31
100
119
78
68
59
86
90
6
17
19. Route the Swivel High Cable (74) through the Swivel
Upright (5) and over a 4 1/2” Pulley (119). Attach the
Pulley inside the Upright with a 3/8” x 2 3/4” Bolt
(101), two 3/8” Washers (91), two 1/2” Spacers (89),
and a 3/8” Nylon Locknut (87).
Attach a 3/8” x 2 1/2” Bolt (18), two 3/8” Washers
(91), and a 3/8” Nylon Locknut (87) to the Swivel
Upright (5).
19
87
74
91
87
91
101
89
89
91
91
18
5
119