Filter
Top Products
18.
Locate and open the parts bags labeled “CABLE
ASSEMBLY” and “PULLEYS.”
Lubricate the 3/8” x 7” Bolt (30) with grease. Attach
the Swivel Cage (76) to the Swivel Carriage (46)
with the Bolt and a 3/8” Nylon Locknut (87).
Locate the Swivel High Cable (74), which is
126 1/2” long and has a ball on one end and a
threaded bolt on the other end. Wrap the Cable
around a 3 1/2” Pulley (78). Attach two Pulleys to
the Swivel Cage (76) with two 3/8” x 1 3/4” Bolts
(93) and two 3/8” Nylon Locknuts (87).
11
16. Press a 1 1/2” x 2” Inner Cap (21) into the Right
Butterfly Arm (26). Wet the lower end of the Arm with
soapy water. Slide a Long Pad (54) onto the Arm.
Attach a Press Handle (27) to the Right Butterfly
Arm (26) with two 5/16” x 3/4” Button Head Screws
(51) and two Nut Clips (108). Slide the Long Pad
(54) down so that the bottom is flush with the lower
end of the Arm. Press a 1” Round Inner Cap (29)
into the Press Handle. Wet the Press Handle with
soapy water. Slide a Long Handgrip (28) onto the
Press Handle.
Lubricate a 3/8” x 2” Bolt (100) with grease. Attach
a Pivot Bracket (70) to the Right Butterfly Arm (26)
with the Bolt and a 3/8” Nylon Jamnut (113). Do not
overtighten the Nylon Jamnut; the Pivot Bracket
must be able to pivot easily. Repeat this step
with the Left Butterfly Arm (25).
17. Lubricate a 3/8” x 3” Button Head Bolt (104) and
both sides of two Plastic Washers (56) with grease.
Attach the Right Butterfly Arm (26) to the Butterfly
Frame (47) with the Bolt, the two Plastic Washers,
two Butterfly Caps (57), two 3/8” Washers (91), and
a 3/8” Nylon Jamnut (113) as shown. Make sure
that the recessed sides of the Plastic Washers
are fitted over the welded bushing in the
Butterfly Arm. Do not overtighten the Nylon
Jamnut; the Butterfly Arm must be able to pivot
easily.
Repeat this step with the Left Butterfly Arm (25).
16
CABLE ASSEMBLY
74
18
78
78
87
93
76
87
17
IMPORTANT: Refer to the Cable Identification
Chart on page 26 for help identifying the
cables. Do not overtighten the bolts and
nuts attaching the pulleys. The pulleys must
be able to turn freely.
26
47
113
56
104
91
57
57
91
25
21
100
Lubricate
70
113
26
25
51
29
28
27
54
108
30
46