Filter
Top Products
23
ATTACHING THE AB STRAP TO THE AB PULLEY
STATION
Attach the Ab Strap (35) to the Low Cable (86) at the
ab pulley station with a Cable Clip (33).
ATTACHING AND REMOVING THE SEAT
To attach the Seat (17), set the bracket on the Rear
Seat Frame (16) onto the pins on the Ab Upright (1).
Attach the Rear Seat Frame to the Ab Upright with
the M8 x 70mm Carriage Bolt (77) and the Seat Knob
(30).
For some exercises, the Seat (17) must be removed.
First, be sure that the chain is not attached to the leg
lever (see ATTACHING THE LEG LEVER TO THE
LOW PULLEY STATION below). Next, remove the
Seat Knob (30) and the M8 x 78mm” Carriage Bolt
(77) from the Rear Seat Frame (16). Lift the Rear
Seat Frame off the Ab Upright (1).
ATTACHING THE LEG LEVER TO THE LOW
PULLEY STATION
To use the Leg Lever (15), the seat must be attached
to the front upright (see ATTACHING AND REMOV-
ING THE SEAT above).
Attach one end of the Chain (34) to the Low Cable
(86) with a Cable Clip (33).
Attach the other end of
the Chain to the Eyebolt (79) with another Cable Clip.
ADJUSTING THE LEG PRESS PLATE
Remove the Lock Pin (73) from the
Adjustment Tube
(10).
Align the holes in the Leg Press Arm (9) with the
desired set of holes in the
Adjustment
T
ube (10). Re-
insert the Lock Pin (73) through the holes in the Leg
Press Arm and the holes in the Adjustment Tube.
Make sure that the hook on the Lock Pin is
clipped in place on the
Adjustment T
ube.
17
30
1
15
79
86
10
9
73
Hook
33
34
77
16
86
33
35