Filter
Top Products
11
17. Wet the lower end of the Left Fly Arm (6) with
soapy water. Slide a Large Pad (22) onto the Left
Fly
Arm.
Repeat this step with the Right Fly
Arm (5).
18. Locate and open the parts bags labeled
“CABLE ASSEMBLY”, “CABLES”, and
“PULLEYS.”
During steps 19 through 49, refer to the CABLE
DIAGRAMS on pages 26 and 27 of this manual
to verify proper cable routing. Before beginning
this section, fully unwind the five cables and iden-
tify the cables by comparing the lengths and the
ends. The approximate length of each cable, in
inches, is listed after the key number in the draw-
ing.
IMPORTANT: While assembling the cables, do
not overtighten the bolts and locknuts attach-
ing the pulleys; the pulleys must be able to
turn freely.
19. Identify the Butterfly Cable (89)—this is the
second shortest Cable. Attach one end of the
Butterfly Cable to the Right Fly
Arm (5) with an
M8 x 22mm Shoulder Bolt (51) and an M8 Nylon
Locknut (40). Make sure the flat edge of the
Cable is against the Fly Arm.
19
17
18
CABLE ASSEMBLY
5
6
22
88—238”
40
5
51
89
86—109”
85—100”
89—82”
87—72”
Flat
Edge