Filter
Top Products
12
20. Wrap the Butterfly Cable (89) around a 90mm
Pulley (82) as shown. Attach the Pulley and a
Cable
Trap (80) to the bracket on the Leg Press
Upright (4) with an M10 x 48mm Bolt (50) and an
M10 Nylon Locknut (42).
The Cable T
rap must
be oriented to hold the Cable in the groove of
the Pulley.
21. Wrap the Butterfly Cable (89) under a 90mm
Pulley (82). Attach the Pulley and a Cable Trap
(80) between the single hole ends of two Pulley
Plates (31) with an M10 x 48mm Bolt (50) and the
M10 Nylon Locknut (42). Make sure that the
Cable Trap is positioned to hold the Cable in
place.
22. Wrap the Butterfly Cable (89) over a 90mm Pulley
(82) as shown. Attach the Pulley and a Cable
Trap (80) to the other side of the bracket on the
Leg Press Upright (4) with an M10 x 48mm Bolt
(50) and an M10 Nylon Locknut (42).
The Cable
Trap must be oriented to hold the Cable in the
groove of the Pulley.
23. Note: The Left Fly Arm (6) is shown removed
for easier part identification.
Attach the Butterfly Cable (89) to the Left Fly Arm
(6) with an M8 x 22mm Shoulder Bolt (51) and an
M8 Nylon Locknut (40). Make sure the flat edge
of the Cable is against the Fly Arm.
23
20
21
22
6
End with
two holes
should be
down
82
80
42
31
4
89
82
50
80
4
42
89
82
50
80
89
50
40
51
89
42
Flat
Edge