Filter
Top Products
54
55
56
21
57.
Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to be sure that the cables move smoothly over
the pulleys. If one of the cables does not move smoothly
, find and correct the problem.
IMPORT
ANT
: If the
cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE
DIAGRAMS on page 26 and 27 of this manual for proper cable routing. If there is any slack in the
cables, you will need to remove the slack by tightening the cables. See MAINTENANCE on page 25.
54. Insert a Pad Tube (28) into the Rear Seat Frame
(16). Slide two Foam Pads (29) onto the ends of
the Pad
Tube.
Insert the other Pad
Tube (28) into the Leg Lever
(15). Slide two Foam Pads (29) onto the ends of
the Pad Tube.
55. Attach the Large Backrest (19) to the Leg Press
Upright (4) with two M6 x 63mm Machine Screws
(64) and two M6 Washers (37).
56. Insert an M6 x 63mm Carriage Bolt (60) through
the center hole in a Seat Plate (41). Attach the
Seat Plate to the Seat (17) with two M6 x 16mm
Screws (59).
Insert the M6 x 63mm Carriage Bolt (60) through
the indicated hole in the Front Seat Frame (8).
Thread an M6 Nylon Locknut (44) with an M6
Washer (37) onto the Carriage Bolt.
Attach the other end of the Seat (17) to the Front
Seat Frame (8) with an M6 Washer (37) and an
M6 x 63mm Machine Screw (64). Tighten the
M6 Nylon Locknut (44).
37
4
19
64
17
59
60
8
37
44
41
64
16
15
29
28
29