Filter
Top Products
18
43. Route the High Cable (85) under a 90mm Pulley
(82). Attach the Pulley and a Cable Trap (80) to
the single hole end of the Pulley Plates (31) with
an M10 x 48mm Bolt (50) and the M10 Nylon
Locknut (42).
Make sure that the Cable T
rap is
positioned to hold the Cable in place.
44. Wrap the High Cable (85) around a 90mm Pulley
(82). Attach the Pulley to the Top Frame (2) with
an M10 x 48mm Bolt (50) and an M10 Nylon
Locknut (42).
The Cable must be routed from
the direction shown.
45. Attach the High Cable (85) to a Small “U”-bracket
(32) with an M8 Nylon Locknut (40) and an M8
Washer (20). Do not completely tighten the
Locknut. It should be threaded onto the end of
the Cable so that two threads show past the
Locknut (see the inset drawing).
Attach the Small “U”-bracket (32) to the indicated
Weight Tube (25) with an M8 x 45mm Bolt (68)
and an M8 Nylon Locknut (40).
46.
Locate the Low Cable (86). Wrap the Low Cable
over a 90mm Pulley (82).
Attach the Pulley and
both Pulley Covers (94) to the
Ab Upright (1) with
the M10 x 97mm Bolt (95), two M10 Washers
(38), and an M10 Nylon Locknut (42).
Do not
overtighten the Locknut; the Pulley should
turn easily
.
Make sure that the Cable is
between the Pulley and the post, and that the
Pulley Covers are turned so the wide tabs are
on the indicated side.
46
43
44
45
85
80
50
31
42
Post
1
86
Wide
tabs
must be
on this
side
38
38
95
94
94
82
End with two
holes should
be down
50
82
2
42
32
68
85
40
20
40
25
85
40
32
20
82
85