Filter
Top Products
8
7. With the Seat (12) oriented as shown, attach the
Seat to the Seat Carriage (11) using four M6 x
16mm Screws (31).
7
8. Slide the Seat (12) onto the Rail (8). Make sure the
Seat is oriented as shown, with the pop pin on
the indicated side.
9. Press a 50mm Square Inner Cap (47) into the top
of the Rail Leg (9). Press the Rail Leg Cap (34)
onto the bottom of the Rail Leg. Attach the Bumper
(25) to the Rail Leg using an M4 x 16mm Screw (26).
Using the Union Bolt Set (61), attach the Rail Leg
(9) to the Rail (8). Do not overtighten the Union Bolt
Set. The Rail Leg must be able to pivot freely for
storage.
Slide the Short Lock Pin (21) into the other hole in
the Rail (8) and the Rail Leg (9). Press the Lock
Pin all the way through the Rail and the Rail
Leg.
8
9
12
Wide End
11
31
12
Pop Pin
8
34
47
21
61
61
25
26
9
8
10. Press a 45mm Square Inner Cap (29) into each end
of the Leg Lever (10).
Slide the Short Cable (19) through the indicated
hole in the Rail Leg (9). Attach the Short Cable to
the Leg Lever (10) using an M10 x 60mm Bolt (38),
two M10 Flat Washers (44), two 21mm Spacers
(41), and an M10 Nylon Locknut (42).
10
42
44
44
38
19
41
29
10
9
29