Filter
Top Products
10
15
16
17
14. Route the Long Cable (18) around the remaining
Cable Pulley (50). Slide the Cable Pulley into a
Pulley Bracket (49) and secure it using an M10 x
27mm Bolt (51) and an M10 Nylon Locknut (42).
Attach the Large Cable Clip (36) and a Cord Ring
(16) to the Pulley Bracket (49). Attach the Cord
Ring to the hooks at the high pulley station.
15. Slide an M10 x 67mm Bolt (48) with an M10 Flat
Washer (44) through the bottom set of holes in the
Rail Leg (9). Make sure the Bolt is under the
Short Cable (19). Secure the Bolt with an M10 Flat
Washer (44) and an M10 Nylon Locknut (42).
Slide the Leg Lever Pulley (24) into the hole in the
Rail Leg (9). Make sure the Short Cable (19) fits
into the groove of the Leg Lever Pulley. Attach the
Pulley to the Rail Leg (9) using an M10 x 67mm
Bolt (48), two M10 Flat Washers (44), two 12.5mm
Spacers (35), and an M10 Nylon Locknut (42).
16. Press a 3/4Ó Round Inner Cap (27) into each end of
both Pad Tubes (28). Slide the Pad Tubes through
the holes in the Rail Leg (9) and the Leg Lever
(10). Slide Foam Pads (30) onto the ends of the
Pad Tubes.
17. Press a Handgrip (17) onto each end of the Lat Bar
(56).
18. Make sure all parts are properly tightened. The
use of the remaining parts will be explained on
pages 11 and 12.
14
18
24
42
35
35
19
44
9
30
30
9
10
17
17
56
27
27
28
44
48
50
51
42
49
36
16