Filter
Top Products
7
4. Slide the indicated end of the Right Brace (4) into
the large hole in the Rear Stabilizer (3). Attach the
Right Brace to the Rear Stabilizer using an M10 x
67mm Bolt (48), two M10 Flat Washers (44), and
an M10 Nylon Locknut (42). Attach the bracket on
the Right Brace to the Frame (1, 2) using two M10
x 42mm Bolts (46), two M10 Flat Washers (44), and
two M10 Nylon Locknuts (42).
Attach the Left Brace (5, not shown) to the Rear
Stabilizer (3) and the Frame (1, 2) in the same
manner.
Tighten all Nylon Locknuts used in steps 1 to 4.
4
3
2
1
46
44
48
46
44
42
42
4
3. Press a 51mm Round Outer Cap (20) onto each
end of the Rear Stabilizer (3).
Attach the Rear Stabilizer (3) to the Base (7) using
two M10 x 67mm Bolts (48), two M10 Flat Washers
(44), and two M10 Nylon Locknuts (42). Make sure
the Rear Stabilizer is turned as shown, with the
large holes facing up. Do not tighten Nylon
Locknuts yet.
3
42
44 48
7
3
20
20
5. Lubricate an M10 x 127mm Bolt (43). Using the Bolt
and an M10 Nylon Locknut (42), attach the Rail (8)
to the bracket on the Lower Frame (2). Do not over-
tighten the Nylon Locknut. The Rail must be able to
pivot freely for storage. Slide the Medium Lock Pin
(58) through the indicated holes in the Lower Frame
and the Rail.
5
8
42
58
2
43
6. Bolt the six Seat Wheels (32) to the inside of the
Seat Carriage (11) using six M6 x 33mm Shoulder
Bolts (33), six Spacers (60), and six M6 Nylon
Locknuts (52). Note: The Wheels may already be
attached to the Seat Carriage.
6
32
32
33
60
52
52
52
60
11