Filter
Top Products
6
1. Press a 51mm Round Outer Cap (20) onto each
end of the Front Stabilizer (6). Make sure the welded
bolts are facing up.
With the help of another person, pivot the Upper
Frame (1) so that it aligns with the Lower Frame (2)
as shown. Secure the Upper and Lower Frames in
place by tightening the two M10 x 36mm Button
Head Bolts (45) and M10 Nylon Locknuts (42).
Place the Frame (1, 2) on the welded bolts on the
Front Stabilizer (6).
2. While another person holds the Upper Frame (2)
upright, place the Base (7) on the welded bolts on
the Front Stabilizer (6). Attach the Base and the
Frame (1, 2) to the Front Stabilizer using two M10
Nylon Locknuts (42). Do not tighten the Nylon
Locknuts yet.
1
1
2
45
45
42
6
Welded Bolts
6
20
20
2
Before beginning assembly, carefully read the
following information and instructions:
¥ Place all parts of the weight system in a cleared
area and remove the packing materials; do not
dispose of the packing materials until assembly
is completed.
¥ Read all assembly steps before you begin.
¥ For help identifying small parts used in
assembly, use the PART IDENTIFICATION
CHART on page 5. Note: Some small parts
may have been pre-attached for shipping. If a
part is not in the parts bag, check to see if it
has been pre-attached.
¥ Tighten all parts as you assemble them, unless
instructed to do otherwise.
¥ As you assemble the weight system, make sure
that all parts are oriented as shown in the
drawings.
THE FOLLOWING TOOLS (NOT INCLUDED)
ARE REQUIRED FOR ASSEMBLY:
¥ Two adjustable wrenches
¥ One phillips screwdriver
¥ One rubber mallet
¥ Lubricant, such as grease or petroleum jelly,
and soapy water are also needed.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Assembly
2
1
42
7