Filter
Top Products
6
2. Slide the Front Upright (42) onto the 5/16” x
2 1/2” Carriage Bolts (1) in the Base (4). Hand
tighten a 5/16” Nylon Locknut (3) onto each
Carriage Bolt. Do not tighten the Nylon
Locknuts yet.
Press a 1” Square Inner Cap (65) into the Front
Upright (42).
3. Press a 2” Square Inner Cap (27) into each end
of the Top Frame (55). Press a 1 3/4” Square
Inner Cap (44) into each end of the crossbar on
the Top Frame. Press two Round Inner Caps (77)
into the top of the crossbar.
Attach the Top Frame (55) to the Front Upright
(42) and the Rear Upright (56) with four 5/16” x
2 3/4” Bolts (11), four 5/16” Flat Washers (8), and
four 5/16” Nylon Locknuts (3).
Tighten the Nylon Locknuts used in steps 1–3.
4. Set two Weight Bumpers (19) onto the bracket on
the Base (4) as shown.
Stack the six Weights (25) on the Weight
Bumpers (19). Be sure that all of the Weights are
turned so the large pin grooves are on the bottom
of the Weights and on the same side of the
weight stack. Be careful not to tip the stack of
Weights.
4
2
3
42
65
3
1
4
11
11
77
8
44
44
27
27
55
56
42
3
Crossbar
25
Pin Groove
19
4
Bracket
3
8