Filter
Top Products
11
19. Locate the Short Cable (58). Lay the Short
Cable in the bracket on the Base (4). Attach the
3 1/2” Pulley (15) to the bracket with a 3/8” x 2”
Bolt (12) and a 3/8” Nylon Locknut (21). Be sure
that the end of the Cable with the ball is on
the indicated side of the bracket.
20. Route the Short Cable (58) around the 3 1/2”
Pulley (15) attached to the lower hole in the Front
Upright (42). See the inset drawing. Be sure
that the Cable Trap (66) is turned to hold the
Cable in place and that the Cable is routed
around the Pulley as shown. Tighten the 3/8”
Nylon Locknut (21) and the 3/8” x 3 3/4” Bolt (71).
21. Route the Short Cable (58) around the 3 1/2”
Pulley (15) attached to the Press Frame (17). Be
sure that the Cable Trap (66) is turned to hold
the Cable in place and that the Cable is routed
around the Pulley as shown. Tighten the 3/8”
Nylon Locknut (21) and the 3/8” x 3 1/2” Bolt (not
shown).
19
58
Bracket
Ball
15
12
21
4
21
58
58
21
15
66
21
17
42
15
71
58
Inset shows view
from other side
42
66
15
20