Filter
Top Products
15
29. Press a 3/4” Round Inner Cap (34) into each end
of both 12 1/2” Pad Tubes (28).
Insert one 12 1/2” Pad Tube (28) into the Seat
Frame (36). Slide a 5 1/2” Pad (30) onto each
end of the Pad Tube.
Insert the other 12 1/2” Pad Tube (28) into the
Leg Lever (29). Slide a 5 1/2” Pad (30) onto each
end of the Pad Tube.
30. Attach the Preacher Pad (79) to the Preacher
Post (78) with two 1/4” x 3/4” Screws (18).
29
30
34
28
34
29
78
79
18
30
36
30
31. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to be sure that the cables move smoothly over
the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the
cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE
DIAGRAM on page 20 of this manual for proper cable routing. If there is any slack in the cables, you
will need to remove it by tightening the cables; see TROUBLE-SHOOTING AND MAINTENANCE on
page 19.