Filter
Top Products
9
10. Press a 60mm Square Inner Cap (55) into each end
of the Top Crossbar (9). Attach the Top Crossbar to
the Uprights (1) using four Joint Plates (12), eight
M10 x 80mm Bolts (41), and eight M10 Nylon
Locknuts (11). Do not tighten the Nylon Locknuts
yet.
Secure the Top Crossbar (9) to the Weight Guides
(18) using two M10 x 30mm Bolts (38) and two M10
Small Washers (6).
11. Press Carriage Bushings (27) into the ends of the
Weight Carriage (22). Press 50mm Round Inner
Caps (25) into the ends of the weight tube on the
Weight Carriage.
Insert an M10 x 20mm Bolt (26) into the bracket on
the Weight Carriage (22).
Slide the Weight Carriage (22) onto the Rear
Upright (2) as shown. Make sure that the Weight
Carriage and the Rear Upright are oriented as
shown.
9
38
38
55
55
11
1
1
18
18
41
41
12
12
11
6
6
10
12. Refer to the inset drawing. Press a Carriage
Bushing (27) into the top of the Carriage Stop (28)
as shown.
Slide the Carriage Stop (28) onto the lower end of
the Rear Upright (2). Attach the Carriage Stop to
the Rear Upright with an M8 x 70mm Bolt (30) and
an M8 Nylon Locknut (54).
Slide the Rear Upright (2) onto the bracket on the
Rear Base (3). Attach the Rear Upright to the Rear
Base using two M10 x 65mm Bolts (56), four M10
Small Washers (6), and two M10 Nylon Locknuts
(11). Do not tighten the Nylon Locknuts yet.
28
2
30
56
6
3
Bracket
6
11
54
12
27
28
22
26
27
27
25
25
Weight Tube
2
Angled End
11