Filter
Top Products
8
7. Press three 45mm Square Inner Caps (17) into the
Leg Lever (18) as shown. Press a 25mm Round
Inner Cap (41) into the indicated end of the Weight
Tube (21).
Attach the Weight Tube (21) to the Leg Lever (18)
with an M8 x 58mm Bolt (49), two M8 Flat Washers
(50), a 10mm Spacer (48), and an M8 Nylon
Locknut (51). Press an Angled Outer Cap (43) onto
the end of the Weight Tube.
7
17
17
21
41
17
49
48
50
18
50
51
43
9. Press two 3/4Ó Round Inner Caps (12) into each of
the three Pad Tubes (38). Slide the Pad Tubes
through the indicated holes in the Front Leg (19)
and the Leg Lever (18).
Slide two Foam Pads (10) onto each Pad Tube (38).
10. Attach the Curl Pad (44) to the Curl Post (42) with
two M6 x 16mm Screws (3). Insert the Curl Post
into the Front Leg (19) and secure it with the Curl
Post Knob (36).
9
10
38
38
12
19
18
12
12
44
19
42
3
36
12
10
10
10
10
8. Lubricate an M10 x 65mm Bolt (46). Attach the Leg
Lever (18) to the Front Leg (19) with the Bolt and
an M10 Nylon Locknut (11). Do not overtighten
the Nylon Locknut; the Leg Lever must be able
to pivot freely.
8
18
11
19
46