Filter
Top Products
6
1. Press a 50mm Square Inner Cap (55) into the indi-
cated end of the Front Leg (19). Insert a 50mm
Thick Inner Cap (35) into the bottom of the Front
Leg.
Attach the Front Leg (19) to the Bench Frame (5)
using two M10 x 65mm Bolts (46), two M10
Washers (6), and two M10 Nylon Locknuts (11).
1
¥ Assembly requires two people.
¥ Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
¥ Tighten all parts as you assemble them, unless
instructed to do otherwise.
¥ For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
¥ As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
The following tools (not included) are required
for assembly:
¥ Two adjustable wrenches
¥ One rubber mallet
¥ One standard screwdriver
¥ One phillips screwdriver
¥ Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Assembly
Make Things Easier
Everything in this manual is designed to ensure
that the weight bench can be assembled
successfully by anyone. However, the weight
bench has many parts, and the assembly
process will take time. Setting aside plenty of
time will make the process go more smoothly.
2. Press a 50mm Square Outer Cap (54) onto each
end of the Stabilizer (37). Attach the Bench Frame
(5) to the Stabilizer using two M10 x 58mm
Carriage Bolts (52) and two M10 Nylon Locknuts
(11).
2
55
35
46
46
19
5
11
6
5
52
37
54
54
11