Filter
Top Products
10
14. Press two Weight Rest Bushings (23) into a Weight
Rest (47) as shown. Pull the Weight Rest Knob (31)
and slide the Weight Rest onto one of the Front
Uprights (1). Hold the Weight Rest at the desired
height and tighten the Weight Rest Knob into one of
the adjustment holes in the Front Upright.
Attach the other Weight Rest (47) to the other Front
Upright (1) in the same way. Make sure that both
Weight Rests are at the same height.
15. Press a 60mm Square Inner Cap (9) into one of the
Front Uprights (1). Attach two Upper Support Plates
(56) to the Front Upright with two M10 x 78mm
Bolts (33) and two M10 Nylon Locknuts (11). Do
not tighten the Nylon Locknuts yet.
Repeat this step with the other Front Upright (1, not
shown).
9
1
56
33
11
56
31
23
23
47
Adjustment
Holes
1
14
16. Attach a Rear Upright (25) to the Left Base (2) and
the indicated Upper Support Plates (56) with four
M10 x 78mm Bolts (33) and four M10 Nylon
Locknuts (11). Do not tighten the Nylon Locknuts
yet.
Attach the other Rear Upright (25) to the Right
Base (7, not shown) and the other Upper Support
Plates (56) in the same manner.
Tighten all nylon locknuts used in steps 11
through 16.
11
2
33
11
56
33
25
16
15