Filter
Top Products
8
7. Press two 3/4Ó Round Inner Caps (47) into the ends
of a Pad Tube (48). Slide the Pad Tube through the
large hole in the Front Leg (2) as shown. Slide a
Large Foam Pad (33) onto each end of the Pad
Tube.
Attach the Leg Lever (9) to the Front Leg (2) using
an M10 x 64mm Bolt (46) and an M10 Nylon
Locknut (45).
7
8. Press 1Ó Square Inner Caps (39) into the ends of
both Backrest Tubes (20). Lubricate an M10 x
168mm Bolt (40). Attach the Backrest Tubes to the
Bench Frame (1) with the lubricated Bolt, two M10
Flat Washers (54), and an M10 Nylon Locknut (45).
Do not overtighten the Locknut. You must be
able to freely pivot the Backrest Tubes (20).
Press two 1Ó Round Inner Caps (21) into the
Adjustment Tube (37). With the pins on the
Adjustment Tube facing downward, slide the
Adjustment Tube into the adjustment brackets on
the Uprights (4,5).
Tighten the Nylon Locknuts used in step 2.
9. Attach the Seat (16) to the Bench Frame (1) using
two M6 x 16mm Screws (56), one M6 x 62mm
Screw (38), and one M6 Flat Washer (51).
8
9
33
33
46
9
45
47
48
2
40
54
54
1
45
21
Pin
Bracket
21
37
4
5
39
16
56
38
51
1
39
20