Filter
Top Products
7
4. Press two 38mm Square Inner Caps (32) into the
ends of the Left Fly Arm (8). Press a 1Ó Round Inner
Cap (21) into the end of the weight tube of the Fly
Arm. Slide a Weight Stop (34) over the weight tube.
Press two 1Ó Round Inner Caps (21) into a Fly Arm
Pad Tube (10). Attach the Fly Arm Pad Tube to the
Left Fly Arm (8) using an M8 x 50mm Bolt (52), two
M8 Flat Washers (41), an M8 Spacer (43), and an
M8 Nylon Locknut (50). The Spacer should fit
snugly into the Left Fly Arm. Slide a Small Foam
Pad (22) onto the Fly Arm Pad Tube.
Assemble the Right Fly Arm (7, not shown) in the
same manner.
22
Weight
Tube
21
21
32
34
21
32
52
41
41
50
43
10
8
4
3. Press a 2 1/2Ó Square Bushing (23) onto both the
Right Upright (5) and the Left Upright (4). Slide the
Weight Rests (6) into the Uprights and secure them
at the desired height with two Adjustment Knobs
(27). Both Weight Rests should be set at the
same height.
3
6
6
5
4
27
23
27
5. Attach the Left Fly Arm (8) to the Left Upright (4)
using two Nylon Bushings (30) and a Spring Clip
(29).
Attach the Right Fly Arm (7) to the Right Upright (5)
in the same manner.
5
8
30
29
4
22
22
5
7
6. Press two 38mm Square Inner Caps (32) into the
ends of the Leg Lever (9). Press a 1Ó Round Inner
Cap (21) into the indicated end of the weight tube.
Slide a Weight Stop (34) over the weight tube.
Press a 1Ó Round Angle Cap (53) onto the opposite
end of the weight tube.
Insert 3/4Ó Round Inner Caps (47) into the ends of
two Pad Tubes (48). Slide the Pad Tubes into the
holes at the ends of the Leg Lever (9). Slide Large
Foam Pads (33) onto the ends of the Pad Tubes.
6
33
32
34
Weight
Tube
32
33
33
21
33
47
47
48
48
53
9