Filter
Top Products
4 ::
1.1 Turning the user interface on and off
The user interface turns itself on when the device is connected to the
mains current. When the user interface has not been used for five
minutes (no heart-rate registered, no keys pressed, no pedalling), it
automatically switches itself to energy-saver state. Alpha 200 is returned
to its active state by pressing any key, starting to pedal or sending heart-
rate signals to the unit. When you restart, Alpha 200 automatically starts
from Training function.
:: Protect Alpha 200 from excess sunlight, because that may fade
the interface box and surface membrane colours. Please also be
careful not to allow Alpha 200 to come into contact with
water. A sharp blow may damage the interface.
:: You can set your language in the Extra function.
1. INSTALLATION ::
Push the T.I.E. interface module carefully into place at the top of the
handlebar support tube. The loose screws hanging from the metal
fastening plate on the bottom of the T.I.E. module must enter the holes
at the top end of the handlebar. Make sure that the module is correctly in
place and tighten the fastening screws.